Attaches 3/16” to 3/4” plywood to 20-8 gauge metal. Wafer head provides a greater bearing surface than Pan or Hex Drillers, with a low-profile head exposure.
Specifications:
Gauge: #10
Length: 1-7/16-in
Head Type: Thin wafer
Recess Type: #2 Phillips
Thread Type: Single lead
Coating: GrabberGard
24 threads per inch
Superfast #3 drill point
Thin wafer head provides a flush finished surface
Winged point creates pilot hole through the plywood
Installation Guidelines:
Use a standard screwgun with a depth-sensitive nose piece. Suggested screwgun specification for optimal performance – 4 amps minimum and RPM range of 0 to 2,500.
- The wafer head is fully seated when the head is flush with the work surface.
- Overdriving my result in fastener failure or strip out of the work surface.
- The fastener must penetrate beyond the metal three full thread pitches.
GrabberGard exterior grade coating
GrabberGard® metal finish is a high-grade proprietary metal surface processing technology that prevents corrosion. It is a duplex coating constituting a zinc substrate and organic polymer topcoat. These layers are bonded together through thermal fusion, and this unique method of combining layers results in a combination of the coating films.
All GRABBER® screw products are manufactured in facilities that are ISO 9002 and ISO 14001 certified and approved. The fasteners comply with ASTM C1513, as referenced in ICC ESR report ESR-1271, are approved for use in structures governed by the International Building Code 2006, 2009, 2012, International Residential Building Code 2006, 2009, and 2012.